HOT & COLD WATER / 09

Hot & Cold Water Ballarat. Find it first.

From a $90 dripping tap to a slab leak that's quietly chewing through your water bill — water work is what we do most. Detection comes before demolition: find the fault before opening up the wall.

Call 0490 123 018 Request a quote →

What's covered

  • Water leak detection
  • Leak and pipe repair
  • Pipe install / replacement
  • Water pressure issues
  • Garden tap installation
  • Bathroom renovation plumbing
Overview

Every water line, diagnosed first.

Acoustic, thermal, dye trace, pressure test — we use the right method for the leak. Most water bills jump 30–100% before anyone notices the cause; catching the leak in week one is a $300 job, catching it in month six is a $30,000 insurance dispute.

Tapware and fittings we install + service

Caroma logoCaroma
Reece logoReece
Fisher & Paykel logoFisher & Paykel
Bosch logoBosch
Rheem logoRheem
Westinghouse logoWestinghouse
Sub-services · 9

What's included.

detection

Water Leak Detection

Acoustic correlation, thermal imaging, dye tracing, and pressure testing — whichever fits the leak type. We pinpoint to within centimetres before any wall comes off.

  • Acoustic leak survey
  • Thermal imaging behind walls
  • Dye trace for pool/planter leaks
  • Slab leak detection
Water Leak Detection
repair

Water Leak Repairs

Once we've located it, the repair is usually quick. Pinhole leaks, failed solder joints, cracked fittings — common fixes with brand-matched parts.

  • Pinhole and joint repair
  • Slab leak repair
  • Pipe section replacement
  • Pressure-test on completion
Water Leak Repairs
install

Water Line Installation

New supply lines for additions, extensions, sheds, granny flats. Copper or PEX depending on application. Sized to flow requirements.

  • Copper or PEX install
  • Sized to flow and pressure
  • Compliance where regulated
  • Insulation in cold zones
Water Line Installation
replacement

Water Line Replacement

Galvanised pipes from pre-1980 Ballarat homes corrode from the inside out — the symptoms are weak flow, rust-coloured water, and recurring pinhole leaks. Replacement is usually a section-by-section copper or PEX rebuild.

  • Galvanised pipe replacement
  • Whole-house re-plumb option
  • Minimal-disruption sectioning
  • Pressure-test before sign-off
Water Line Replacement
meter leak

Water Meter Leaks

If your meter is spinning when nothing's running, you've got a leak between the meter and the house. We isolate, locate, and repair — and we provide documentation if you need to dispute a water bill.

  • Meter isolation test
  • Underground leak location
  • Repair quoted before work
  • Documentation for water authority
Water Meter Leaks
pressure

Water Pressure Issues

Too much pressure damages every fitting in the house and wears out washers fast. Too little, and showers feel like trickles. We pressure-test, install limiters, or upgrade lines as needed.

  • Pressure measurement + report
  • Pressure-limiting valve install
  • Line sizing diagnosis
  • Boost pump option for low-flow
Water Pressure Issues
point install

Water Point Installation

New outlets for fridges with water lines, garden irrigation, outdoor showers, pool top-ups. Backflow-protected per VBA rules.

  • Backflow protection compliant
  • Indoor or outdoor outlets
  • Sized for intended use
  • Insulated in cold-snap zones
Water Point Installation
garden tap

Garden Tap Installation

Outdoor brass tap installs and replacements. Frost-protected fittings for Ballarat winters. Backflow-protected as required by VBA.

  • Brass quarter-turn or compression
  • Backflow prevention device
  • Frost cover for winter
  • Concrete or stud-frame mounting
Garden Tap Installation
reno plumbing

Bathroom Renovation Plumbing

Rough-in for renovation builds. Supply lines and waste pipes set in the wall and floor, pressure-tested, ready for waterproofing and tiling. Then we come back for fit-off once the tiler's done.

  • Two-stage rough-in + fit-off
  • Coordinated with builder/tiler
  • Pressure-test before tiling
  • Compliance on fit-off
Bathroom Renovation Plumbing
FAQ

Common questions about hot & cold water in Ballarat.

Single-room or single-fixture detection: $180–$320. Slab leak (under concrete): $400–$700. Roof or multi-source: $400–$900. Detection is quoted before we start; once found, repair is quoted separately.
Probably yes. About half of hidden leaks have no surface sign — they go into the soil, under the slab, or into a wall cavity. A meter test then pressure test confirms in 30 minutes.
Yes — install a pressure-limiting valve at the meter. Most Australian houses are designed for 500 kPa or less; anything over that shortens the life of every washer and flexi-hose in the house.
Sometimes. Sudden bursts are usually covered; gradual leaks usually aren't. We provide a dated detection report and photos that help support legitimate claims.
Both. We're a full plumbing service. Once we locate the leak we quote the repair. You can take that quote elsewhere if you'd like — most customers ask us to fix it.
Booking

Need a hot & cold water plumber? Get a quote today.

Phone goes straight through. Call for the current Ballarat emergency ETA before we book the job.

Call now · 0490 123 018