GAS PLUMBING / 09

Gas Plumbing Essendon. Type A licensed.

Gas work is licence-only — every regulated job comes with a Certificate of Compliance lodged with Victorian Building Authority (VBA). We cover leaks, line installs, appliance hook-ups and meter work across Essendon and the Inner North-West Melbourne.

Call 0449 963 200 Request a quote →

What's covered

  • Gas leak detection
  • Appliance hook-ups
  • Gas line install / relocation
  • Gas meter work
  • LPG cylinder + regulator
  • Compliance certificates
Overview

Every gas job, certified.

Mains pressure or LPG. Domestic or light commercial. New install or repair. Every regulated job carries a Certificate of Compliance — that's a legal requirement, and it's how your insurance stays valid if something goes wrong later.

Gas appliance brands we install + service

Rinnai logoRinnai
Rheem logoRheem
Bosch logoBosch
Westinghouse logoWestinghouse
Fisher & Paykel logoFisher & Paykel
Caroma logoCaroma
Sub-services · 9

What's included.

leak repair

Gas Leak Repairs

Acting fast on a suspected leak. Isolate at the meter, locate the source with electronic detector + soap-test, repair the joint or replace the fitting, pressure-test the line, lodge the compliance certificate.

  • Electronic gas leak detection
  • Joint and fitting replacement
  • Pressure testing before re-pressurising
  • Carbon monoxide check on flued appliances
Gas Leak Repairs
leak detection

Gas Leak Detection

Suspect a leak but can't see one? Electronic sniffers find the source down to the joint. Common culprits are aged threaded joints, cracked flexible appliance hoses, and worn regulators. The same scan also catches CO leakage from flued appliances.

  • Electronic detector survey
  • Soap-test on joints
  • Carbon monoxide measurement
  • Written report for insurance
Gas Leak Detection
line install

Gas Line Installation

New cooker bench, new bathroom heater, new outdoor BBQ point — anything that needs a new run gets sized, installed, pressure-tested and certified. Copper or stainless flexi where appropriate.

  • Sized to appliance load
  • Mains pressure or LPG
  • Pressure test before commissioning
  • Certificate of Compliance lodged
Gas Line Installation
point move

Gas Point Relocation

Renovating the kitchen or moving the laundry? The cooktop or hot water unit needs the gas point in the right place. We relocate, re-route, and certify — without leaving redundant tees behind walls.

  • Clean removal of old point
  • New point sized correctly
  • No dead-ends or redundant tees
  • Certificate of Compliance
Gas Point Relocation
appliance install

Gas Appliance Installation

Cooktops, ovens, gas log fires, outdoor BBQs, gas hot water — all need a licensed gasfitter to connect, even if you've bought the appliance yourself. We do the connection, pressure-test, and check for CO on flued units.

  • Cooktops, ovens, gas log fires
  • Outdoor BBQs and grills
  • Gas hot water and continuous flow
  • CO test on flued appliances
Gas Appliance Installation
connections

Gas Connections

Joining new appliances to existing lines, capping off retired points, swapping rigid for flexible — the everyday connection work that keeps a gas system safe.

  • Rigid copper joining
  • Flexible hose swaps
  • Cap-off of retired points
  • Compliance documentation
Gas Connections
fitting

Gas Fitting

Full gas fitting service — installs, repairs, alterations, certifications. Type A licensed for domestic and light commercial. Insured and documented.

  • Domestic and light commercial
  • Mains gas + LPG
  • Insurance and warranty backed
  • VBA-lodged compliance
Gas Fitting
meters

Gas Meters

Gas meter relocations and meter upgrades coordinated with your retailer. Common driver: a renovation that moves the meter, or an appliance load that's outgrown the existing meter capacity.

  • Meter relocation coordination
  • Meter upgrade for larger loads
  • Retailer paperwork lifecycle
  • Compliance certificate
Gas Meters
repairs

Gas Repairs

Pilot light not staying lit? Regulator hissing? Ignition fault on the heater? Most gas faults are diagnosable on-site, fixable same visit. Brand-matched parts where possible.

  • Pilot and ignition faults
  • Regulator and valve replacement
  • Flexible hose replacement
  • Same-visit on most repairs
Gas Repairs
FAQ

Common questions about gas plumbing in Essendon.

Hoggs Plumbing Services quotes a fixed price before any work starts in Essendon - you approve the cost upfront with no surprise add-ons. The price depends on the job; call 0449 963 200 for a clear quote on blocked drains, hot water, gas or general plumbing.
Yes. Hoggs Plumbing Services works under Victorian Building Authority (VBA) licensing and issues a Victorian Compliance Certificate on regulated plumbing and gas work across Essendon and Inner North-West Melbourne. Fully licensed and insured.
Hoggs Plumbing Services is a local Inner North-West Melbourne team working near Essendon, so jobs are prioritised by urgency. For a burst pipe, blocked drain or no hot water, phone 0449 963 200 and the team gives an honest arrival window for your Essendon address.
Yes. From Essendon, Hoggs Plumbing Services covers Strathmore, Glenroy, Parkville, Niddrie and the wider Inner North-West Melbourne. Same crew every visit, fully licensed under Victorian Building Authority (VBA).
Hoggs Plumbing Services repairs and replaces hot water systems and carries out gas fitting, leak detection, blocked drains and bathroom plumbing across Essendon. Licensed under Victorian Building Authority (VBA) - call 0449 963 200 to book.
Booking

Need a gas plumbing plumber? Get a quote today.

Phone goes straight through. Call for the current Essendon emergency ETA before we book the job.

Call now · 0449 963 200